Configuring A Vlt Vlan Or Lag In A Pvlan; Creating A Vlt Lag Or A Vlt Vlan - Dell S6000–ON Configuration Manual

VLT LAG Mode
Peer1 Peer2
Access Access
Access Access
Access Access
Access Access
Promiscuo Access
us
Trunk Access

Configuring a VLT VLAN or LAG in a PVLAN

You can configure the VLT peers or nodes in a private VLAN (PVLAN). Because the VLT LAG interfaces are
terminated on two different nodes, PVLAN configuration of VLT VLANs and VLT LAGs are symmetrical
and identical on both the VLT peers. PVLANs provide Layer 2 isolation between ports within the same
VLAN. A PVLAN partitions a traditional VLAN into subdomains identified by a primary and secondary VLAN
pair. With VLT being a Layer 2 redundancy feature, support for configuration of VLT nodes in a PVLAN
enables Layer 2 security functionalities to be achieved. This section contains the following topics that
describe how to configure a VLT VLAN or a VLT LAG (VLTi link) and assign that VLT interface to a PVLAN.

Creating a VLT LAG or a VLT VLAN

1. Configure the port channel for the VLT interconnect on a VLT switch and enter interface
configuration mode
CONFIGURATION mode
interface port-channel id-number.
Enter the same port-channel number configured with the peer-link port-channel command as
described in Enabling VLT and Creating a VLT
NOTE: To be included in the VLTi, the port channel must be in Default mode (no switchport
or VLAN assigned).
2. Remove an IP address from the interface.
966
PVLAN Mode of VLT VLAN
Peer1 Peer2
Secondary Secondary
(Community) (Community)
- Primary VLAN X - Primary VLAN X
Secondary Secondary
(Isolated) (Isolated)
- Primary VLAN X - Primary VLAN X
Secondary Secondary
(Isolated) (Isolated)
- Primary VLAN X - Primary VLAN Y
Secondary Secondary
(Community) (Community)
- Primary VLAN Y - Primary VLAN X
Primary Secondary
Primary/Normal Secondary
Domain.
ICL VLAN Mac
Membership Synchronization
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No No
No No
No No
No No
No No
No No
Virtual Link Trunking (VLT)