Configure A Route Map For Route Redistribution - Dell S6000–ON Configuration Manual

• Specify an OSPF area or ISIS level for redistributed routes.
CONFIG-ROUTE-MAP mode
set level {backbone | level-1 | level-1-2 | level-2 | stub-area}
• Specify a value for the BGP route's LOCAL_PREF attribute.
CONFIG-ROUTE-MAP mode
set local-preference value
• Specify a value for redistributed routes.
CONFIG-ROUTE-MAP mode
set metric {+ | - | metric-value}
• Specify an OSPF or ISIS type for redistributed routes.
CONFIG-ROUTE-MAP mode
set metric-type {external | internal | type-1 | type-2}
• Assign an IP address as the route's next hop.
CONFIG-ROUTE-MAP mode
set next-hop ip-address
• Assign an IPv6 address as the route's next hop.
CONFIG-ROUTE-MAP mode
set ipv6 next-hop ip-address
• Assign an ORIGIN attribute.
CONFIG-ROUTE-MAP mode
set origin {egp | igp | incomplete}
• Specify a tag for the redistributed routes.
CONFIG-ROUTE-MAP mode
set tag tag-value
• Specify a value as the route's weight.
CONFIG-ROUTE-MAP mode
set weight value
To create route map instances, use these commands. There is no limit to the number of set commands
per route map, but the convention is to keep the number of set filters in a route map low. Set commands
do not require a corresponding match command.

Configure a Route Map for Route Redistribution

Route maps on their own cannot affect traffic and must be included in different commands to affect
routing traffic.
Route redistribution occurs when Dell Networking OS learns the advertising routes from static or directly
connected routes or another routing protocol. Different protocols assign different values to redistributed
routes to identify either the routes and their origins. The metric value is the most common attribute that
is changed to properly redistribute other routes into a routing protocol. Other attributes that can be
changed include the metric type (for example, external and internal route types in OSPF) and route tag.
104
Access Control Lists (ACLs)