Dell S6000–ON Configuration Manual page 518

Hide thumbs Also See for S6000–ON:

Table of Contents

Apply all other configurations to each interface in the redundant pair such that their configurations are

identical, so that transition to the backup interface in the event of a failure is transparent to rest of the

Figure 67. Configuring Redundant Layer 2 Pairs without Spanning Tree

You configure a redundant pair by assigning a backup interface to a primary interface with the

switchport backup interface command. Initially, the primary interface is active and transmits traffic

and the backup interface remains down. If the primary fails for any reason, the backup transitions to an

active Up state. If the primary interface fails and later comes back up, it remains as the backup interface

for the redundant pair.

If the interface is a member link of a LAG, the following primary/backup interfaces are also supported:

primary interface is a physical interface, the backup interface can be a physical interface

primary interface is a physical interface, the backup interface can be a static or dynamic LAG

primary interface is a static or dynamic LAG, the backup interface can be a physical interface

primary interface is a static or dynamic LAG, the backup interface can be a static or dynamic LAG

In a redundant pair, any combination of physical and port-channel interfaces is supported as the two

interfaces in a redundant pair. For example, you can configure a static (without LACP) or dynamic (with

LACP) port-channel interface as either the primary or backup link in a redundant pair with a physical

Troubleshooting