Configuring The Interface Sampling Size - Dell S6000–ON Configuration Manual

the interface, whether it supports IEEE 802.1Q tagging or not, and the VLANs to which the interface
belongs.
Dell#show interfaces switchport
Name: TenGigabitEthernet 3/1/1
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 3/1/2
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 3/1/3
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 3/1/4
802.1QTagged: True
Vlan membership:
Vlan 2
--More--

Configuring the Interface Sampling Size

Although you can enter any value between 30 and 299 seconds (the default), software polling is done
once every 15 seconds. So, for example, if you enter "19", you actually get a sample of the past 15
seconds.
All LAG members inherit the rate interval configuration from the LAG.
The following example shows how to configure rate interval when changing the default value.
To configure the number of seconds of traffic statistics to display in the show interfaces output, use the
following command.
• Configure the number of seconds of traffic statistics to display in the show interfaces output.
INTERFACE mode
rate-interval
Example of the rate-interval Command
The bold lines shows the default value of 299 seconds, the change-rate interval of 100, and the new rate
interval set to 100.
Dell#show interfaces
TenGigabitEthernet 1/1/1 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:01:9e:d9
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 1d23h44m
Queueing strategy: fifo
0 packets input, 0 bytes
Input 0 IP Packets, 0 Vlans 0 MPLS
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
414
Interfaces