Dell S6000–ON Configuration Manual page 630

3. Enter ROUTER OSPF mode.
CONFIGURATION mode
router ospf process-id [vrf]
Process ID is the ID assigned when configuring OSPFv2 globally.
4. Configure the area as a stub area.
CONFIG-ROUTER-OSPF-id mode
area area-id stub [no-summary]
Use the keywords no-summary to prevent transmission into the area of summary ASBR LSAs.
Area ID is the number or IP address assigned when creating the area.
Example of the show ip ospf database database-summary Command
To view which LSAs are transmitted, use the show ip ospf database process-id database-
summary command in EXEC Privilege mode.
Dell#show ip ospf 34 database database-summary
OSPF Router with ID (10.1.2.100) (Process ID 34)
Area ID Router Network S-Net S-ASBR Type-7 Subtotal
2.2.2.2 1
3.3.3.3 1
Dell#
To view information on areas, use the show ip ospf process-id command in EXEC Privilege mode.
Enabling Passive Interfaces
A passive interface is one that does not send or receive routing information.
Enabling passive interface suppresses routing updates on an interface. Although the passive interface
does not send or receive routing updates, the network on that interface is still included in OSPF updates
sent via other interfaces.
To suppress the interface's participation on an OSPF interface, use the following command. This
command stops the router from sending updates on that interface.
• Specify whether all or some of the interfaces are passive.
CONFIG-ROUTEROSPF- id mode
passive-interface {default | interface}
The default is enabled passive interfaces on ALL interfaces in the OSPF process.
Entering the physical interface type, slot, and number enables passive interface on only the identified
interface.
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/
subport information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a port channel interface, enter the keywords port-channel then a number.
630
0 0 0
0 0 0
0 1
0 1
Open Shortest Path First (OSPFv2 and OSPFv3)