Writing Managed Object Values - Dell S6000–ON Configuration Manual

• Read the value of a single managed object.
snmpget -v version -c community agent-ip {identifier.instance |
descriptor.instance}
• Read the value of the managed object directly below the specified object.
snmpgetnext -v version -c community agent-ip {identifier.instance |
descriptor.instance}
• Read the value of many objects at once.
snmpwalk -v version -c community agent-ip {identifier.instance |
descriptor.instance}
Examples of Reading the Value of Managed Objects
In the following example, the value "4" displays in the OID before the IP address for IPv4. For an IPv6 IP
address, a value of "16" displays.
> snmpget -v 2c -c mycommunity 10.11.131.161 sysUpTime.0
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (32852616) 3 days, 19:15:26.16
> snmpget -v 2c -c mycommunity 10.11.131.161 .1.3.6.1.2.1.1.3.0
The following example shows reading the value of the next managed object.
> snmpgetnext -v 2c -c mycommunity 10.11.131.161 .1.3.6.1.2.1.1.3.0
SNMPv2-MIB::sysContact.0 = STRING:
> snmpgetnext -v 2c -c mycommunity 10.11.131.161 sysContact.0
The following example shows reading the value of the many managed objects at one time.
> snmpwalk -v 2c -c mycommunity 10.11.131.161 .1.3.6.1.2.1.1
SNMPv2-MIB::sysDescr.0 = STRING: Dell
Dell Operating System Version: 1.0
Dell Application Software Version: E_MAIN4.9.4.0.0
Copyright (c) 1999-2014 by Dell
Build Time: Mon May 12 14:02:22 PDT 2008
SNMPv2-MIB::sysObjectID.0 = OID: SNMPv2-SMI::enterprises.6027.1.3.1
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (32920954) 3 days, 19:26:49.54
SNMPv2-MIB::sysContact.0 = STRING:

Writing Managed Object Values

You may only alter (write) a managed object value if your management station is a member of the same
community as the SNMP agent, and the object is writable.
Use the following command to write or write-over the value of a managed object.
• To write or write-over the value of a managed object.
snmpset -v version -c community agent-ip {identifier.instance |
descriptor.instance}syntax value
Example of Writing the Value of a Managed Object
> snmpset -v 2c -c mycommunity 10.11.131.161 sysName.0 s "R5"
SNMPv2-MIB::sysName.0 = STRING: R5
Simple Network Management Protocol (SNMP)
Real Time Operating System Software
843