Configuration Task List For Radius - Dell S6000–ON Configuration Manual

• If an ACL is absent.
• If there is a very long delay for an entry, or a denied entry because of an ACL, and a message is
logged.
NOTE: The ACL name must be a string. Only standard ACLs in authorization (both RADIUS and
TACACS) are supported. Authorization is denied in cases using Extended ACLs.
Auto-Command
You can configure the system through the RADIUS server to automatically execute a command when
you connect to a specific line.
The auto-command command is executed when the user is authenticated and before the prompt
appears to the user.
• Automatically execute a command.
auto-command
Privilege Levels
Through the RADIUS server, you can configure a privilege level for the user to enter into when they
connect to a session.
This value is configured on the client system.
• Set a privilege level.
privilege level

Configuration Task List for RADIUS

To authenticate users using RADIUS, you must specify at least one RADIUS server so that the system can
communicate with and configure RADIUS as one of your authentication methods.
The following list includes the configuration tasks for RADIUS.
• Defining a AAA Method List to be Used for RADIUS
• Applying the Method List to Terminal Lines
• Specifying a RADIUS Server Host
• Setting Global Communication Parameters for all RADIUS Server Hosts
• Monitoring RADIUS
For a complete listing of all Dell Networking OS commands related to RADIUS, refer to the Security
chapter in the Dell Networking OS Command Reference Guide.
NOTE: RADIUS authentication and authorization are done in a single step. Hence, authorization
cannot be used independent of authentication. However, if you have configured RADIUS
authorization and have not configured authentication, a message is logged stating this. During
authorization, the next method in the list (if present) is used, or if another method is not present, an
error is reported.
To view the configuration, use the show config in LINE mode or the show running-config
command in EXEC Privilege mode.
Defining a AAA Method List to be Used for RADIUS
To configure RADIUS to authenticate or authorize users on the system, create a AAA method list.
Default method lists do not need to be explicitly applied to the line, so they are not mandatory.
To create a method list, use the following commands.
Security
(mandatory)
(optional)
(mandatory)
(mandatory except when using default lists)
(optional)
783