Dell S6000–ON Configuration Manual page 744

Hide thumbs Also See for S6000–ON:

Table of Contents

Enabling RIP Globally

By default, RIP is not enabled in Dell Networking OS.

To enable RIP globally, use the following commands.

Enter ROUTER RIP mode and enable the RIP process on Dell Networking OS.

CONFIGURATION mode

Assign an IP network address as a RIP network to exchange routing information.

ROUTER RIP mode

network ip-address

Examples of Verifying RIP is Enabled and Viewing RIP Routes

After designating networks with which the system is to exchange RIP information, ensure that all devices

on that network are configured to exchange RIP information.

The Dell Networking OS default is to send RIPv1 and to receive RIPv1 and RIPv2. To change the RIP

version globally, use the version command in ROUTER RIP mode.

To view the global RIP configuration, use the show running-config command in EXEC mode or the

show config command in ROUTER RIP mode.

Dell(conf-router_rip)#show config

network 10.0.0.0

Dell(conf-router_rip)#

When the RIP process has learned the RIP routes, use the show ip rip database command in EXEC

mode to view those routes.

Dell#show ip rip database

Total number of routes in RIP database: 978

160.160.0.0/16