Erpm Behavior On A Typical Dell Networking Os; Decapsulation Of Erpm Packets At The Destination Ip/ Analyzer - Dell S6000–ON Configuration Manual

Hide thumbs Also See for S6000–ON:

Table of Contents

ERPM Behavior on a typical Dell Networking OS

The Dell Networking OS is designed to support only the Encapsulation of the data received / transmitted

at the specified source port (Port A). An ERPM destination session / decapsulation of the ERPM packets at

the destination Switch are not supported.

Figure 100. ERPM Behavior

As seen in the above figure, the packets received/transmitted on Port A will be encapsulated with an

IP/GRE header plus a new L2 header and sent to the destination ip address (Port D's ip address) on the

sniffer. The Header that gets attached to the packet is 38 bytes long.

If the sniffer does not support IP interface, a destination switch will be needed to receive the

encapsulated ERPM packet and locally mirror the whole packet to the Sniffer or a Linux Server.

In order to achieve the decapsulation of the original payload from the ERPM header. The below two

methods are suggested :

Using Network Analyzer

– Install any well-known Network Packet Analyzer tool which is open source and free to

Port Monitoring