Dell S6000–ON Configuration Manual page 475

Hide thumbs Also See for S6000–ON:

Table of Contents

To configure IS-IS globally, use the following commands.

Create an IS-IS routing process.

CONFIGURATION mode

router isis [tag]

tag: (optional) identifies the name of the IS-IS process.

Configure an IS-IS network entity title (NET) for a routing process.

ROUTER ISIS mode

net network-entity-title

Specify the area address and system ID for an IS-IS routing process. The last byte must be 00.

For more information about configuring a NET, refer to

Enter the interface configuration mode.

CONFIGURATION mode

interface interface

Enter the keyword interface then the type of interface and slot/port information:

For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/

subport information.

For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port

information.

For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

For a port channel interface, enter the keywords port-channel then a number.

For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Enter an IPv4 Address.

INTERFACE mode

ip address ip-address mask

Assign an IP address and mask to the interface.

The IP address must be on the same subnet as other IS-IS neighbors, but the IP address does not

need to relate to the NET address.

Enter an IPv6 Address.

INTERFACE mode

ipv6 address ipv6-address mask

ipv6 address: x:x:x:x::x

mask: The prefix length is from 0 to 128.

The IPv6 address must be on the same subnet as other IS-IS neighbors, but the IP address does not

need to relate to the NET address.

Enable IS-IS on the IPv4 interface.

ROUTER ISIS mode

Intermediate System to Intermediate System

Troubleshooting