Enabling Null Vlan As The Default Vlan - Dell S6000–ON Configuration Manual

Enabling Null VLAN as the Default VLAN

In a Carrier Ethernet for Metro Service environment, service providers who perform frequent
reconfigurations for customers with changing requirements occasionally enable multiple interfaces, each
connected to a different customer, before the interfaces are fully configured.
This presents a vulnerability because both interfaces are initially placed in the native VLAN, VLAN 1, and
for that period customers are able to access each other's networks. Dell Networking OS has a Null VLAN
to eliminate this vulnerability. When you enable the Null VLAN, all ports are placed into it by default, so
even if you activate the physical ports of multiple customers, no traffic is allowed to traverse the links
until each port is place in another VLAN.
To enable Null VLAN, use the following command.
• Disable the default VLAN, so that all ports belong to the Null VLAN until configured as a member of
another VLAN.
CONFIGURATION mode
default-vlan disable
Default: the default VLAN is enabled (no default-vlan disable).
916
Virtual LANs (VLANs)