•
Set the number of ARP retries.
CONFIGURATION mode
arp retries number
The default is 5.
The range is from 1 to 20.
•
Set the exponential timer for resending unresolved ARPs.
CONFIGURATION mode
arp backoff-time
The default is 30.
The range is from 1 to 3600.
•
Display all ARP entries learned via gratuitous ARP.
EXEC Privilege mode
show arp retries
ICMP
For diagnostics, the internet control message protocol (ICMP) provides routing information to end
stations by choosing the best route (ICMP redirect messages) or determining if a router is reachable
(ICMP Echo or Echo Reply).
ICMP error messages inform the router of problems in a particular packet. These messages are sent only
on unicast traffic.
Configuration Tasks for ICMP
The following lists the configuration tasks for ICMP.
•
Enabling ICMP Unreachable Messages
For a complete listing of all commands related to ICMP, refer to the Dell Networking OS Command Line
Reference Guide.
Enabling ICMP Unreachable Messages
By default, ICMP unreachable messages are disabled.
When enabled, ICMP unreachable messages are created and sent out all interfaces.
To disable and re-enable ICMP unreachable messages, use the following commands.
•
To disable ICMP unreachable messages.
INTERFACE mode
no ip unreachable
•
Set Dell Networking OS to create and send ICMP unreachable messages on the interface.
INTERFACE mode
IPv4 Routing
431