Configure A Route Map For Route Redistribution; Configure A Route Map For Route Tagging - Dell Z9500 Configuration Manual

CONFIG-ROUTE-MAP mode
set origin {egp | igp | incomplete}
• Specify a tag for the redistributed routes.
CONFIG-ROUTE-MAP mode
set tag tag-value
• Specify a value as the route's weight.
CONFIG-ROUTE-MAP mode
set weight value
To create route map instances, use these commands. There is no limit to the number of set commands per route map, but the
convention is to keep the number of set filters in a route map low. Set commands do not require a corresponding match
command.

Configure a Route Map for Route Redistribution

Route maps on their own cannot affect traffic and must be included in different commands to affect routing traffic.
Route redistribution occurs when Dell Networking OS learns the advertising routes from static or directly connected routes or
another routing protocol. Different protocols assign different values to redistributed routes to identify either the routes and
their origins. The metric value is the most common attribute that is changed to properly redistribute other routes into a routing
protocol. Other attributes that can be changed include the metric type (for example, external and internal route types in OSPF)
and route tag. Use the redistribute command in OSPF, RIP, ISIS, and BGP to set some of these attributes for routes that are
redistributed into those protocols.
Route maps add to that redistribution capability by allowing you to match specific routes and set or change more attributes
when redistributing those routes.
In the following example, the redistribute command calls the route map static ospf to redistribute only certain static
routes into OSPF. According to the route map static ospf, only routes that have a next hop of Tengigabitethernet interface
1/1 and that have a metric of 255 are redistributed into the OSPF backbone area.
NOTE: When re-distributing routes using route-maps, you must create the route-map defined in the redistribute
command under the routing protocol. If you do not create a route-map, NO routes are redistributed.
Example of Calling a Route Map to Redistribute Specified Routes
router ospf 34
default-information originate metric-type 1
redistribute static metric 20 metric-type 2 tag 0 route-map staticospf
!
route-map staticospf permit 10
match interface TenGigabitEthernet 1/1
match metric 255
set level backbone

Configure a Route Map for Route Tagging

One method for identifying routes from different routing protocols is to assign a tag to routes from that protocol.
As the route enters a different routing domain, it is tagged. The tag is passed along with the route as it passes through different
routing protocols. You can use this tag when the route leaves a routing domain to redistribute those routes again. In the
following example, the redistribute ospf command with a route map is used in ROUTER RIP mode to apply a tag of 34 to
all internal OSPF routes that are redistributed into RIP.
Example of the redistribute Command Using a Route Tag
!
router rip
Access Control Lists (ACLs) 119