Set The Command Language From The Printer Web Page; Set The Command Language From The Main Menu - Intermec PM23c User Manual

Set the Command Language from the Printer Web Page

Set the Command Language from the Main Menu

PM23c, PM43, and PM43c Mid-Range Printer User Manual
To set the command language from the printer web page, you need to
turn on the printer and connect to your Ethernet or Wi-Fi network.
1 Make sure that the printer has media and ribbon (if necessary)
installed.
2 On your PC, open a browser.
3 In the Location or Address bar, type the printer IP address and
press Enter. The printer web page appears.
4 Click Login. The Login page appears.
5 Type your Username and Password and click Login. The default
username is itadmin and the default password is pass.
6 Click the Configure tab.
7 Click System Settings > General.
8 Select a different printer command language from the Command
Language list, and then click Save.
9 Click the Services tab.
10 Click Reboot Printer, and then click Reboot. The printer restarts
in the command language you selected.
If you have a full touch printer, you can use this procedure to change
the printer command language from the Main Menu.
1 From the Ready screen, press the Main Menu button.
2 From the Main Menu, pressSettings > System Settings > General.
3 Scroll down until you reach Command Language.
4 Use the horizontal scroll bar to select the command language you
want to use and then save your change.
5 Turn the printer off and then on. The printer starts up in the
command language you selected.
Chapter 1 — About the Printer
19