Intermec PM23c User Manual page 105

PM23c, PM43, and PM43c Mid-Range Printer User Manual
Maintenance and Error Alerts (Continued)
Error Alert
Odometer (User
Resettable)
Printhead Too Hot
Printhead Not
Detected
Faulty Dot
Replace Printhead
Clean Printhead
No RFID Tag Found
RFID Not Installed
Upgrading Firmware The printer is going to start upgrading the firmware.
Printer is Rebooting
Started
Motor Too Hot
Chapter 5 — Troubleshoot the Printer
Solution
The printer has reached a limit set in the Odometer
(User Resettable) setting in Maintenance Alerts for
the amount of media printed since the last reset.
The printhead is overheated and needs to cool down.
Wait for printing to resume automatically.
The printer is not detecting the printhead. Check to
make sure the printhead is installed and that the
printhead cable is firmly connected to the printhead.
The printhead has reached the number of faulty dots
set in the Faulty Dots setting in Maintenance Alerts.
You may need to replace the printhead.
The printer has reached a limit set in the Replace
Printhead setting in Maintenance Alerts for the
amount of media to print before replacing the
printhead. Replace the printhead.
The printer has reached a limit set in the Clean
Printhead setting in Maintenance Alerts for the
amount of media to print before cleaning the
printhead. Clean the printhead.
The printer can not find an RFID tag.
You are attempting to write to a tag, but the printer
does not support RFID. You must install the RFID
module in the printer to be able to write to RFID
tags.
Do not try to send anything to the printer.
The printer is going to restart. Wait until the printer
is ready before attempting to communicate with it.
The printer is in the process of starting up.
The printer motor has reached its maximum
operating temperature limit. Let the motor cool
down before you resume printing.
91