System Maintenance Alert Settings - Intermec PM23c User Manual

Appendix B — Default Settings

System Maintenance Alert Settings

System Maintenance Alert Settings
Setting
Odometer (User
Resettable)
Odometer (Printer)
Odometer (Current
Printhead)
Replace Printhead
Clean Printhead
Faulty Dot
Ribbon Low Diameter
144
This section describes the system maintenance alert settings, such as
the odometer distance. To view these settings:
• From the printer Main Menu, select Settings > System Settings >
Maintenance Alerts.
• From the printer web page, click the Configure tab, System
Settings > Maintenance Alerts.
Description
Sets the length of media (in meters) that the printer prints
before the Odometer (User Resettable) alert is sent, if this
alert is configured. Unit of measurement is defined in the
Unit of Measure parameter. Range is 0 to 4294967295.
Sets the length of media (in meters) that the printer prints
before the Odometer (Printer) alert is sent. Unit of
measurement is defined in the Unit of Measure parameter.
Range is 0 to 4294967295.
Sets the length of media (in meters) that the printer prints
before the Odometer (Current Printhead) alert is sent, if
this alert is configured. Unit of measurement is defined in
the Unit of Measure parameter. Range is 0 to 4294967295.
Sets the length of media (in meters) that the printer prints
before the Replace Printhead alert is sent, if this alert is
configured. Unit of measurement is defined in the Unit of
Measure parameter. Range is 0 to 4294967295.
Sets the length of media (in meters) that the printer prints
before the Clean Printhead alert is sent, if this alert is
configured. Unit of measurement is defined in the Unit of
Measure parameter. Range is 0 to 4294967295.
Sets the number of faulty dots on the printhead before the
Faulty Dot alert is sent, if this alert is configured. Range is
0 to 4294967295.
Sets the minimum diameter of the ribbon roll before the
Ribbon Low alert is sent, if this alert is configured. Range is
0 to 200 mm.
PM23c, PM43, and PM43c Mid-Range Printer User Manual
Default
0
0
0
0
0
0
0