Intermec PM23c User Manual page 51

PM23c, PM43, and PM43c Mid-Range Printer User Manual
5 Route the ribbon through the print mechanism and pull out
approximately 20 cm (8 inches) of ribbon leader.
The dotted line in this illustration shows how to load ribbon with
the ink wound in.
6 Turn the ribbon takeup hub counterclockwise until the ribbon
becomes tight and runs wrinkle-free through the print mechanism.
7 Load media.
8 Turn the printhead lift lever clockwise to lower the printhead.
9 Close the media cover.
10 Press the Print button to advance the media.
11 Configure the printer for the correct media type: media with gaps,
black mark, continuous fixed length, or continuous variable
length.
12 Set the print method to ribbon (TTR).
13 Calibrate the sensors on the printer. You can calibrate the media
from the Main Menu (Wizards > Calibration > Media) on a full
touch printer or from the web page (Services > Media
Calibration) for all models of the printer.
Chapter 2 — Set Up the Printer
37