Dpt Type—Type - Panasonic KX-TDA200 Programming Manual

3.5 [1-1] Slot—Port Property - Extension Port
Feature Manual References
13.1.2 Paralleled Telephone
DPT Type—Type
Selects the port type.
To change the port type of an extension port, follow the steps below:
1.
Set the status of the extension port to "OUS".
2.
Change the port type of the extension port, then click Apply.
3.
Set the status of the extension port to "INS".
When changing the port type of an extension port for which
6.1 [4-1-1] Wired Extension—Extension Settings screen, the
first.
When changing the type of a port for which one or more SDN buttons are set (except when changing
between PC Console and Telephone), all SDN buttons customized for that device will be deleted. When
you attempt to apply the new settings, a warning message is displayed showing the slot and port number
for which SDN buttons will be deleted. If you do not wish to delete SDN buttons for this port, click
Cancel.
Default
Normal
Value Range
Normal: For connecting a DPT
DSS: For connecting a DSS Console (A maximum of 4 [with the KX-TDA50], 8 [with the KX-TDA100/
KX-TDA200] or 64 [with the KX-TDA600] DSS Consoles can be connected to the PBX.)
VM (DPT): For connecting a Panasonic VPS through DPT Integration
PC Console: For connecting a PC Console (A maximum of 2 [with the KX-TDA50] or 8 [with the KX-TDA100/
KX-TDA200/KX-TDA600] PC Consoles can be connected to the PBX.)
Maintenance Console Location
3.5 [1-1] Slot—Port Property - Extension Port
Programming Manual References
3.6 [1-1] Slot—Port Property - Extension Port—Connection Command
Feature Manual References
19.1.3 Voice Mail (VM) Group
3.1.21 CTI (Computer Telephony Integration)
DPT Type—Location No.
Specifies the location number of the connected DSS Console or PC Console. This setting is only available
when DPT Type—Type on this screen is set to DSS or PC Console.
Note that, depending on system traffic, there may be a limit to the number of PC Consoles that can be supported
by a single DLC/DHLC card.
When changing the location number of a DSS Console for which one or more SDN buttons are set, all SDN
buttons customized for that device will be deleted. When you attempt to apply the new settings, a warning
92 PC Programming Manual
Wireless XDP has been set on the
Wireless XDP setting must be deleted
Document Version 2008-11