Panasonic KX-TDA200 Programming Manual page 42

2.6.1 Utility—Diagnosis
DP detection (CO->Ext)
BELL detection (Ext->CO)
Speech path (Ext->CO)
Speech path (CO->Ext)
To perform a pair port test
1.
From the Utility menu, select Diagnosis.
2.
Click on the Status cell of the extension card to be tested, and set it to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
4.
Select the Pair Port Test option.
A new window will be displayed. The card you selected in Step 3 will be shown in the Extension Line Slot
No. drop-down list.
5.
From the CO Line Slot No. drop-down list, select the slot number of the CO line card you want to test.
6.
From the CO Line Port No. drop-down list, select the port number of the CO line you want to test.
7.
Click Test.
The error report will be displayed.
8.
Select an option:
•
Click Capture if you want to save the displayed information.
1.
Enter a file name, or select a file to overwrite.
2.
Click Save.
•
Click Cancel to return to the Diagnosis screen.
Network Loopback Test (KX-TDA100/KX-TDA200/KX-TDA600 only)
Performs a remote loopback test on the PRI23 card.
Note
•
To perform this test, it is necessary to set
—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only) to "Enable".
•
The version of the PRI23 card must be 2.000 or later.
To perform a network loopback test
1.
From the Utility menu, select Diagnosis.
2.
Click on the Status cell of the PRI23 card, and set it to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
4.
Select the Loopback Type option.
A new window will be displayed.
5.
Select Point1 or Point2 depending on the type of loopback test you want to perform
The available selections may vary depending on the hardware version of the card.
6.
Click Apply.
Preparation for the test is complete. The test will start automatically.
7.
After the test is complete, select Release and click Apply.
8.
Click Close to return to the Diagnosis screen.
42 PC Programming Manual
DP generation/detection from CO line to extension
BELL generation/detection from extension to CO line
Speech path from extension to CO line
Speech path from CO line to extension
Loopback Test started by Network in 3.14 [1-1] Slot
Document Version 2008-11