Set Audit - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > set audit

set audit

This command changes the general settings of the audit log function. Use the "show audit" command to dis-
play the audit log function settings that are configured by this command.
■ Syntax
set audit [-mode {enable | disable}]
[-server1-function {disable | rfc3164 | rfc5424}]
audit_log_server1
[-server1
[-server1-port {maintenance | remote}]
[-server2-function {disable | rfc3164 | rfc5424}]
audit_log_server2
[-server2
[-server2-port {maintenance | remote}]
■ Parameter
-mode
-server1-function
-server1
-server1-port-number
] [-server1-port-number
] [-server2-port-number
Optional. This parameter specifies whether to enable the audit log function.
enable The audit log function is enabled.
disable The audit log function is disabled.
Optional. This parameter specifies whether to enable syslog server 1. If omitted, the existing
setting is not changed. If omitted, the existing setting is not changed. This parameter cannot
be specified when the audit log function is disabled.
disable Syslog server 1 is disabled.
rfc3164 Syslog server 1 is enabled and uses message format based on RFC3164.
rfc5424 Syslog server 1 is enabled and uses message format based on RFC5424.
Optional. This parameter specifies syslog server 1. Only one server can be specified. The server
name format should be IPv4 standard notation (a base 256 "d.d.d.d" string), IPv6 address
format, or a fully qualified domain name (FQDN). The types of IPv6 addresses that can be
specified are global addresses (including 6to4 addresses), link local addresses, and unique
local addresses. Up to 63 alphanumeric characters can be specified. If omitted, the existing
setting is not changed. This parameter cannot be specified when the audit log function is dis-
abled.
Example: -server1 192.168.1.20
Example: -server1 fd80::abd0:223:ad
Example: -server1 foo.bar
Optional. This parameter specifies syslog server 1's UDP port number for the syslog protocol.
Specify the port number within 1 to 5 digits. The port number cannot be set above 65535. If
omitted, the setting is not changed. The default value is 514. This parameter cannot be speci-
fied when the audit log function is disabled.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
port_number
]
port_number
]
584
P2X0-1030-09ENZ0