Show Advanced-Copy-Parameters - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > show advanced-copy-parameters

show advanced-copy-parameters

This command displays the current settings of the Advanced Copy parameters.
■
Syntax
show advanced-copy-parameters
■ Parameter
No parameters.
■ Output
# Resolution
A
# Advanced Copy Table Size
B
# EC/OPC Priority
C
# Current EC/OPC Priority
D
# SDPE
E
# Advanced Copy Table Usage Threshold [80%]
F
# Used Advanced Copy Table Size
G
# Usable Advanced Copy Size
H
# Copy Schedule Mode
I
A: Resolution
B: Advanced Copy table size
C: EC/OPC priority and EC/OPC rate mode that is currently set in the system (Example: Auto, Very Low Priority, Low
Priority, Middle Priority, High Priority)
D: EC/OPC priority that is currently used
E: Resolution of a snap data pool volume
F: Threshold value of the Advanced Copy table usage
G: Advanced Copy table size that is currently used
H: Usable Advanced Copy table size
I: Copy Schedule Mode (Example: Session balancing, Destination RAID Group balancing)
■
Example(s)
The following example displays the Advanced Copy parameters:
CLI> show advanced-copy-parameters
Resolution
Advanced Copy Table Size
EC/OPC Priority
Current EC/OPC Priority
SDPE
Advanced Copy Table Usage Threshold [80%]
Used Advanced Copy Table
Usable Advanced Copy Size
Copy Schedule Mode
[x2]
[128MB]
[Auto]
[Low Priority]
[1GB]
[30MB]
[20GB]
[Session balancing]
[x2]
[128MB]
[Auto]
[Low Priority]
[1GB]
Size [30MB]
[20GB]
[Session balancing]
393
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0