Set Host-Sense - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-sense

set host-sense

This parameter specifies the preset host sense corresponding to the specific host operating system.
■
Syntax
set host-sense
{-host-response-number
-preset {no-conversion | linux | windows|custom}
[-original-sk
[-converted-sk
[-converted-ascq
■ Parameter
-host-response-number
or
-host-response-name
-preset
-original-sk Optional. This parameter specifies the sense key that corresponds to the sense of the
-original-asc
-original-ascq
host_response_numbers
original_sk original_asc
] [-original-asc
converted_sk
] [-converted-asc
converted_ascq
]
This parameter specifies the host response identifier that is to be used to set the host sense.
One or more parameters can be specified. For details, refer to
(page 24).
This parameter specifies the preset host sense corresponding to the specific host operating
system.
no-conversion
It will revert to the default host sense value (Default).
linux Linux host (when Linux GRMPD is not in use).
windows Windows host (when GR/ETERNUS MPD and its device driver are not in use).
custom Custom setting. The following sense parameters can be specified only when this
setting is selected.
conversion source. This parameter can only be specified when "-preset custom" is selected. This
parameter must be specified by using either a hexadecimal number or the wildcard (*).
Optional. This parameter specifies the sense code, which is an additional sense code, that
corresponds to the sense of the conversion source. This parameter can only be specified when
"-preset custom" is selected. This parameter must be specified by using either a hexadecimal
number or the wildcard (*).
Optional. This parameter specifies the sub sense code, which is an additional sense code
qualifier that corresponds to the sense of the conversion source. This parameter can only be
specified when "-preset custom" is selected. This parameter must be specified by using either a
hexadecimal number or the wildcard (*).
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
| -host-response-name
original_ascq
] [-original-ascq
converted_asc
]
300
host_response_names
}
]
"1.2.12 Host Response Syntax"
P2X0-1030-09ENZ0