Show Network - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.3 Network Management > show network

show network

This command displays the Ethernet configuration parameters.
■
Syntax
show network
■ Parameter
No parameters.
■ Output
# MNT port Enable
Maintenance port name (MNT port) and [Enable/Disable]
# IPv4
Whether IPv4 settings are enabled or disabled [Enable/Disable]
# Master IP
# Slave IP
# Subnet Mask
# Gateway
# Primary DNS
# Speed and Duplex Auto Negotiation
# Allowed IP1
...
# Allowed IP15 192.168.9.0,255.255.255.0
# Wake on LAN
# Ipv6
Whether IPv6 settings are enabled or disabled [Enable/Disable]
# Master Link Local IP
# Master Connect IP
# Slave Link Local IP
# Slave Connect IP
# Length of Subnet Prefix
# Gateway
Enable
192.168.1.1
IP address of MNT port on master CM
192.168.1.2
IP address of MNT port on slave CM
This is not displayed for a single-controller type.
255.255.255.0
Subnet mask of MNT port
192.168.1.250
Gateway address of MNT port
192.168.1.253 Secondary DNS 192.168.1.254
Primary and secondary DNS IP address
Connection speed of MNT port
192.168.2.0,255.255.255.0
IP address Subnet mask
IP address Subnet mask
The list of Allowed IP1-16 is accessible terminals through MNT port.
Disable
It indicates if a function of the Wake on LAN is enabled on the MNT port.
Enable
fe80:2:3:4:5:6:7:8
Link local IP address (Master)
1:2:3::6:7:8
Connect IP address (Master)
fe80:b:c:d:e:f:10:11
Link local IP address (Slave). This is not displayed for the single-controller
type.
a:b:c:d::
Connect IP address (Slave). This is not displayed for the single-controller
type.
64
Prefix length
c0:a8:1:fa:ff:ff:ff:0
Gateway
458
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Allowed IP2 10.10.10.0,255.255.255.0
IP address
Allowed IP16 10.10.17.0,255.255.255.0
IP address
Subnet mask
Subnet mask
P2X0-1030-09ENZ0