Create User - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.1 User Management > create user

create user

This command creates a new user account. User names that are already registered cannot be used.
■
Syntax
create user -name
■ Parameter
-name
-role
-function
■ Example(s)
This example changes the role of the user account named "user1" to the Account Admin Role:
CLI> create user -name user1 -role AccountAdmin -function enable
name role
-role [-function {enable | disable}]
This parameter specifies a unique name for the new user account. Usable characters are
alphanumeric (case-sensitive), exclamation mark (!), hyphen (-), underscore (_), and dot (.)
characters. A minimum of 1 letter and a maximum of 32 letters are required.
This parameter specifies the role. For details, refer to
Total Administrator role
Maintainer Maintenance operator
SecurityAdmin
Security administrator
AccountAdmin
Account administrator
StorageAdmin
ETERNUS DX Disk storage system administrator
Administrator
Total administrator
Monitor Monitor
Software Software
User-defined role
Role that is created using the "create role" command.
Optional. This parameter specifies whether the user account will be enabled.
enable The user account created is enabled immediately (default).
disable The user account is created but not enabled.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
"4.1.1 Role" (page
362
356).
P2X0-1030-09ENZ0