Copy Affinity-Group - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > copy affinity-group

copy affinity-group

This command copies information from one affinity group to another affinity group.
■
Syntax
copy affinity-group -name
{-source-ag-number
■ Parameter
-name
-source-ag-number
or
-source-ag-name
■ Example(s)
The following example copies the definitions contained in the affinity group named "AG001", and creates a
new affinity group named "AG002" with those same definitions:
CLI> copy affinity-group -name AG002 -source-ag-name AG001
name
source_ag_number
| -source-ag-name
This parameter specifies the affinity group name of the target affinity group. Only one name
can be specified at the same time.
This parameter specifies the affinity group identifier which is the source of the copy. Only one
affinity group can be specified at the same time. For details, refer to
Syntax" (page 24).
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
source_ag_name
256
}
"1.2.11 Affinity Group
P2X0-1030-09ENZ0