Set Snmp-View - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.3 Network Management > set snmp-view

set snmp-view

This command adds or deletes sub-trees to the specified SNMP MIB view. This command is not available when
the delete SNMP MIB view setting is already used for a SNMP community, SNMP user or SNMP trap.
Regarding the SNMP sub-trees name, the following rules apply for descriptions.
• Up to 251 characters can be specified.
• Names must be specified as a combination of numbers and periods (.). Example: "1.3.5"
• A combination of numbers and periods (.) must be used. At least one period (.) must be used. Example:
"15" is NG.
• The number "0" cannot be specified between period (.) characters. Example: "1.0.1" is NG.
• Numbers that begin with 0 cannot be specified. Example: "1.01.1" is NG.
■
Syntax
set snmp-view -view
subtree4
[-subtree4
subtree8
[-subtree8
[-include-subtree
■ Parameter
-view
-subtree1
. . .
-subtree10
-include-subtree
view_name
[-subtree1
subtree5
] [-subtree5
subtree9
] [-subtree9
subtree_numbers ] [-exclude-subtree
This parameter specifies the name of the MIB view that will be changed. Only one view can be
specified at the same time. Up to 32 characters can be specified for a view name and at least
one character must be specified.
Optional. These parameters specify the accessible sub-trees corresponding to the specified MIB
view (up to 10 sub-trees). If omitted, the existing setting is not changed. Each sub-tree must
be unique. If duplex is specified, the command terminates with an error.
To delete a subtree, specify two double quotation marks (""). When two double quotation
marks ("") are specified, all of the subtrees are relocated. Example: -subtree3 "".
Optional. This parameter specifies the "include" subtree type. A value between 1 and 10 can be
specified for the subtree number. Two or more subtree numbers can be specified by using "," or
"-".
If this parameter and the "-exclude-subtree" parameter are omitted, "include" is used as the
default for subtree.
The "-include-subtree" and "-exclude-subtree" parameters cannot both be specified for the
same subtree.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
subtree1 subtree2
] [-subtree2
subtree6
] [-subtree6 ] [-subtree7
subtree10
] [-subtree10 ]
subtree_numbers
478
subtree3
] [-subtree3 ]
subtree7
]
]
P2X0-1030-09ENZ0