Set Host-Group - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-group

set host-group

This command changes the host group name, adds hosts to a host group, and deletes hosts from a host
group.
• A host can be added to or deleted from a host group for which mapping is set.
• A host cannot be deleted from a host group when no hosts belong to the host group after the host is
deleted.
• Up to eight hosts can be set for a single host group.
• Hosts that belong to a host group must have the same host response settings as the host group. When
the same hosts are registered in a new host group A and an existing host group B, the host response
settings for host group B are changed to the host group A settings. In addition, if the same hosts are
registered in host group B and another existing host group C, the host response settings for host group C
are also changed to host group B (and so forth).
• When a host that is added to the new host group A belongs to host group B, the host response settings
for host group B are changed to the host group A settings. In addition, if the same hosts are registered in
host group B and another existing host group C, the host response settings for host group C are also
changed to host group B (and so forth).
■ Syntax
set host-group {-host-group-number
[-host-response-number
host_group_name
[-name
-release-host-number
■ Parameter
-host-group-number
or
-host-group-name
-host-response-number
or
-host-response-name
-name
host_group_number
host_response_number
] [-add-host-number
host_numbers
| - release-host-name
This parameter specifies the host group identifier to be changed. Only one host group can be
specified at the same time. For details, refer to
Optional. This parameter specifies the host response identifier that is to be used to set the host
sense. Only 1one host response can be specified at the same time. If omitted, the existing
setting is not changed. For details, refer to
Optional. This parameter specifies the new host group name. Only 1one name can be specified
at the same time. If omitted, the existing setting is not changed. For details, refer to
Alias Name Syntax" (page 20).
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
| -host-group-name
| -host-response-name
host_numbers
| -add-host-name
host_names
"1.2.16 Host Group Syntax" (page
"1.2.12 Host Response Syntax" (page
320
host_group_name
}
host_response_name
]
host_names
|
]
26).
24).
P2X0-1030-09ENZ0
"1.2.4