Set Eco-Mode - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > set eco-mode

set eco-mode

This command enables or disables the ECO mode. The ECO mode is a power saving function that will turn off
the disk motor when the disks are not being accessed. The ECO function cannot be used unless the ECO mode
is enabled.
■ Syntax
set eco-mode [-mode {enable | disable}]
■ Parameter
-mode
■ Example(s)
The following example enables the ECO mode.
CLI> set eco-mode
The following example disables the ECO mode:
CLI> set eco-mode
Optional. This parameter specifies if the ECO mode is enabled. If omitted, the existing setting
is not changed.
enable ECO mode is enabled.
disable ECO mode is disabled.
-mode enable
-mode disable
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
129
P2X0-1030-09ENZ0