Show Radius - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.1 User Management > show radius

show radius

This command displays the settings of the RADIUS server.
■
Syntax
show radius
■ Parameter
No parameters.
■ Output
# RADIUS authentication
# After error
# Primary server
# Primary port
# Primary port number
# Primary authentication mode
# Primary shared secret
# Primary retry timeout
# Secondary server
# Secondary port
# Secondary port number
# Secondary authentication mode
# Secondary shared secret
# Secondary retry timeout
A: Mode. Display the system's mode.
B: Displays which method used after found error.
C: FQDN or IP address (IPv4 or IPv6) of the primary authentication server.
D: Port that is used for primary settings.
E: Port number of the primary authentication server for the authentication protocol.
F: Authentication method type of the primary authentication server.
G: Shared secret of the primary authentication server.
H: Retry timeout value of the primary authentication server.
I: FQDN or IP address (IPv4 or IPv6) of the secondary authentication server
J: Port that is used for secondary settings.
K: Port number of the secondary authentication server for the authentication protocol.
L: Authentication method type of the secondary authentication server.
M: Shared secret of the secondary authentication server.
N: Retry timeout value of the primary authentication server.
[Enable]
A
[No]
B
[10.21.134.198]
C
[MNT]
D
[1812]
E
[CHAP]
F
[xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx]
G
[20]
H
[10.17.80.6]
I
[RMT]
J
[1912]
K
[PAP]
L
[yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy]
M
[20]
N
376
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0