Show Status - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 2 Status Display
2.1 Storage System Status > show status

show status

This command displays a summary of the system status. It will display if any components in the system are in
an error or warning condition. It does not indicate if host servers are able to access the system.
■ Syntax
show status
■ Parameters
No parameters.
■
Output
Summary status
■ Example(s)
The following example displays a summary of the system status:
CLI> show status
Summary Status
CLI> show status
Summary Status
CLI> show status
Summary Status
Summary of the system status.
Empty The ETERNUS DX Disk storage system is not defined or installed.
Normal The ETERNUS DX Disk storage system is in normal state.
Pinned Data PIN data exists in the ETERNUS DX Disk storage system.
Unused An undefined component is installed in the ETERNUS DX Disk storage system.
Warning A component that is the target for preventive maintenance exists in the ETERNUS DX Disk
storage system.
Maintenance Maintenance is currently being performed on the ETERNUS DX Disk storage system.
Error A component with an error exists in the ETERNUS DX Disk storage system.
Loop Down The ETERNUS DX Disk storage system is in BackEnd Down state.
Not Ready "Not Ready" is a status where an abnormality is detected at a power-off, and I/O access
from the host cannot be received.
Subsystem Down
The ETERNUS DX Disk storage system is not available.
Change Assigned CM
Hot expansion and recovery of the controller is required.
[Normal]
[Error]
[Warning]
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
33
P2X0-1030-09ENZ0