Restrictedchannel; Set Adoptionlist - Symbol WS5000 Series System Reference Manual

8-214
WS5000 Series Switch System Reference Guide
Example
WS5000.(Cfg).SPolicy.[Default Wireless Switch Policy]> name newname
Configuring name...
Status : Success.
WS5000.(Cfg).SPolicy.[newname]>

8.48.4 restrictedchannel

Switch Policy Instance
Changes the prompt to the Restricted Channel context, where channels that cannot be chosen by Automatic
Channel Selection for a particular radio type can be specified.
See Restricted Channel Instance on page 8-218
Syntax
restrictedchannel <radio_type>
Parameters
radio_type Type of radio to configure restricted channels for. Valid values are a, b, g, for 802.11a,
802.11b, or 802.11g, respectively.
Example
WS5000.(Cfg).SPolicy.[Default Wireless Switch Policy]> restrictedchannel A
Radio Restricted Ch.
----- --------------
A 153
A 46
WS5000.(Cfg).SPolicy.[Default Wireless Switch Policy].Restricted.[A]>

8.48.5 set adoptionList

Switch Policy Instance
Adds/removes an entry to/from the access port adoption-inclusion and adoption-exclusion lists. APs that are
in the inclusion list are adopted through a specified access port policy. APs in the exclusion list are never
adopted.
This command to also used to set the default action (adopt or not) for APs that are in neither list.
APs are identified by MAC address. Each entry in either listed as a single MAC address or a range of MAC
addresses.
The adoption lists are based on radio type. There is a different list for each radio type: 802.11a, 802.11b,
802.11g, and frequency hopping radios. In addition, the switch policy contains a master adoption list that is
applied to all radios.
Syntax
set adoptionList <radio> include <start_MAC> [<end_MAC>] <app_name | remove>
set adoptionList <radio> exclude <start_MAC> [<end_MAC>] [remove]
set adoptionList <radio> default allow <app_name>
set adoptionList <radio> default deny [traps <enable | disable>]
for more details.
Description
-----------