Ip Pool Configuration - Symbol WS5000 Series System Reference Manual

set <primary/secondary>
Table 12.3 describes how to configure the server by settings the parameters for each RADIUS server. The VPN
server supports any number of servers:
Table 12.3 RADIUS Authentication Setting
To Parameter used
set the RADIUS host name host
or IP address.
Note To use on-board RADIUS server to authenticate the VPN clients, set any of the
switch interface IP address as the RADIUS IP address (in the configuration above).
set the RADIUS port. Port
Default is 1812
set RADIUS timeout. timeout
Value range is 5-20
millisecs
set RADIUS retry. Valid retry
range 1- 10.
set RADIUS user userpwd
password. (Dummy
password).
Note Some servers require the password attribute to be a non empty string.If this value
is set, this string will be used as password. This password is usually left blank to ensure
that different RADIUS users are authenticated.

12.2.4.3 IP Pool configuration

Table 12.4 lists and describes the CLI commands used to configure the WVPN IP Pool settings:
Table 12.4 IP Pool Configuration
To
enter WVPN Pool configuration
add an IP Pool
remove an IP Pool
<radius_parameter>
CLI command used
WS5000.(Cfg).wvpn.auth.wvpnradius>set ?
set <primary/secondary> host <name/IP>
WS5000.(Cfg).wvpn.auth.wvpnradius>set ?
set <primary/secondary> port <value>
WS5000.(Cfg).wvpn.auth.wvpnradius>set ?
set <primary/secondary> timeout <value>
WS5000.(Cfg).wvpn.auth.wvpnradius>set ?
set <primary/secondary> retry <value>
WS5000.(Cfg).wvpn.auth.wvpnradius>set ?
set <primary/secondary> userpwd <value>
CLI command used
Configure wvpn pool [enter]
WS5000.(Cfg).wvpn.pool>
WS5000.(Cfg).wvpn.pool >add pool <pool name> <begin
IP> <end IP>
WS5000.(Cfg).wvpn.pool >remove pool <pool name>
Configuring the WS5100 WTLS VPN
<value>
12-9