Chassis Context; Set Notify - Symbol WS5000 Series System Reference Manual

8-118
WS5000 Series Switch System Reference Guide

8.21 Chassis Context

Display and manage CPU and system temperature.
Table 8.25 summarizes the commands within this context. Common commands between multiple contexts are
described in further detail in the
Table 8.25 Chassis Context Command Summary
Command
.. or end Terminate a current session and moves up a context, hierarchically.
exit Terminate a current session and returns to the "root" prompt.
? or help Get the command information.
logout or bye Close this session.
clear Clear the screen.
emergencymode Enable or disable Emergency mode.

set notify

Tells the switch to send a notification if the temperature of the CPU or of the
system, in general, rises above a given threshold.
show Display context specific attributes
8.21.1 set notify
Chassis Context
Tells the switch to send a notification if the temperature of the CPU or of the system rises above a given
threshold. Notifications are sent to the local system log, the Syslog, and cause an SNMP trap to be thrown.
IMPORTANT! THE SYSTEM AUTOMATICALLY SHUTS DOWN IF THE CPU OR
!
SYSTEM TEMPERATURE RISES ABOVE 105 DEGREES.
Syntax
set notify <cpu-temperature | system-temperature> <threshold>
Parameters
threshold The temperature threshold is expressed in degrees centigrade and must fall in the range
[0, 105]. The notification is only sent when the temperature rises from below to above
the threshold temperature—it isn't sent when the temperature drops from above to
below the threshold.
Example
WS5000.(Cfg).Chassis> set notify system-temperature 30
Configuring notify temperature...
Status: Success.
Description
-----------
Common Commands section..
Description
Curr Value Max Value
---------- ---------
Ref.
page 8-5
page 8-5
page 8-6
page 8-6
page 8-7
page 8-7
page 8-118
page 8-119
Min Value Notify Value
--------- ------------