Symbol WS5000 Series System Reference Manual page 245

8.19.7.1 set basicRates
Access Port Policy Instance
Sets the basic frequency rates for a given 802.11 radio type.
Syntax
set basicRates <radioType> <rates ...>
Parameters
radioType One of A, B, G, or FH (frequency hopping). Radio values are:
• A – Frequencies 6, 9, 12, 18, 24, 36, 48, 54
• B – Frequencies 1, 2, 5.5, 11
• G – Frequencies 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54
• FH – Frequencies 1, 2
rates A list of frequency values, in Mbps. The list of candidate frequencies depends on the
radio type, as shown in the following table. You can set multiple basic rates by passing
a list of frequencies, e.g.: > set B basicrates 1 2 11
Example
WS5000.(Cfg).APPolicy.[NY_APPolicy]> set basicrates B 1,2
Configuring a Access Port Policy...
Status: Success.
Access Port Policy details for "NY_APPolicy":
Policy Name
Description
Basic Rate for 11a
Supported Rate for 11a
Basic Rate for 11b
Supported Rate for 11b
Basic Rate for 11g
Supported Rate for 11g
Basic Rate for FH
Supported Rate for FH
RF Preamble
RTS Threshold
DTIM Period
Beacon Interval
Allow MUs w/o Spectrum Mgmt
WS5000.(Cfg).APPolicy.[NY_APPolicy]>
8.19.7.2 set beacon
Access Port Policy Instance
WS5000.(Cfg).APPolicy.[Name]> set beacon
Sets the Access Port's radio beacon interval, in milliseconds. Valid intervals are in the range [20, 1000].
Syntax
set beacon <20 - 1000>
Parameters
beacon_interval
: NY_APPolicy
:
: 6,12,24
: 9,18,36,48,54
: 1,2
: 5.5,11
: 1,2,5.5,11
: 6,9,12,18,24,36,48,54
: 1
: 2
: short
: 2347 Bytes
: 10
: 100
: false
8-109
CLI Command Reference