Enable - Dell S4810 Reference Manual

•
Example
Dell(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
Dell(conf-if-te-5/0)#
Dell(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
Dell(conf-if-te-5/0)#
Dell(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
Dell(conf-if-te-5/0)#

enable

Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may
need to enter a password.
S4810
Syntax
enable [level]
Parameters
level
Defaults 15
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Version 9.2(1.0)
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
98
config
(OPTIONAL) Enter a number for a privilege level of Dell
Networking OS. The range is from 0 to 15.
Added support for roles on the Z9000, S6000, S4820T,
S4810, MXL
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Control and Monitoring