Interface Mode - Dell S4810 Reference Manual

FRRP Mode
To enable or configure Force10 Resilient Ring Protocol (FRRP), use FRRP mode. For more information,
refer to Force10 Resilient Ring Protocol
To enter FRRP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol frrp command then the ring ID. The prompt changes to include (conf-frrp-
ring-id).
You can return to CONFIGURATION mode by using the exit command.

INTERFACE Mode

Use INTERFACE mode to configure interfaces or IP services on those interfaces. An interface can be
physical (for example, a Gigabit Ethernet port) or virtual (for example, the Null interface).
To enter INTERFACE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the interface command and then enter an interface type and interface number that is
available on the switch.
The prompt changes to include the designated interface and slot/port number. For example:
Prompt Interface Type
Dell(conf-if)# INTERFACE mode
Gigabit Ethernet interface then the slot/port information
Dell(conf-if-
gi-0/0)#
Ten-Gigabit Ethernet interface then slot/port information
Dell(conf-if-
te-0/0)#
Forty-Gigabit Ethernet interface then slot/port information
Dell(conf-if-
fo-0/0)#
Loopback interface number
Dell(conf-if-
lo-0)#
Null Interface then zero
Dell(conf-if-
nu-0)#
Port-channel interface number
Dell(conf-if-
po-0)#
VLAN Interface then VLAN number (range 1–4094)
Dell(conf-if-
vl-0)#
Management Ethernet interface then slot/port information
Dell(conf-if-
ma-0/0)#
Tunnel interface then tunnel ID.
Dell(conf-if-
tu-0)#
54
(FRRP).
CLI Basics