Permit - Dell S4810 Reference Manual

Version
8.3.10.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.1.0
Usage
Dell Networking OS supports one ingress and one egress IP ACL per interface.
Information
Prior to Dell Networking OS version 7.8.1.0, names are up to 16 characters long.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related
ip access-list extended
Commands
show config

permit

To permit packets from a specific source IP address to leave the switch, configure a filter.
S4810
Syntax
permit {source [mask]| any | host ip-address}
To remove this filter, you have two choices:
•
•
Parameters
source
mask
216
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the non-contiguous mask and added the
monitor option.
Expanded to include the optional QoS order priority for the
ACL entry.
— creates an extended access list.
— displays the current configuration.
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no permit {source [mask] | any | host ip-address}
command.
Enter the IP address in dotted decimal format of the network
from which the packet was sent.
(OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
Access Control Lists (ACL)