Removing A Blank Drive Bezel - Compaq Deskpro AP500 Reference Manual

Removing a Blank Drive Bezel

A blank drive bezel covers bays 5 and 6 when they are not occupied with a
storage device. You will need to remove a drive bezel before installing any
removable media storage device (such as a CD-ROM, diskette, or other device)
in these bay locations. You will not need to replace the drive bezel after the
drive installation.
To remove a blank drive bezel:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the side access panel and front bezel.
3. Refer to the following illustration to remove a blank drive bezel.
Figure 8-2. Removing a blank drive bezel
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
File Name: I-CH08.DOC Last Saved On: 2/11/99 8:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Professional Workstation AP500 Reference Guide
8-3