Configure An Lldp Interface - NETGEAR M4100 Series User Manual

7. Select System
8. Use Transmit Interval to specify the interval in seconds to transmit LLDP frames.
The range is from 5 to 32768 secs. The default value is 30 seconds.
9. Use Transmit Hold Multiplier to specify the multiplier on Transmit Interval to assign TTL.
The range is from 2 to 10 secs.The default value is 4.
10. Use Re-Initialization Delay to specify the delay before re-initialization.
The range is from 1 to 10 secs. The default value is 2 seconds.
11. Use Notification Interval to specify the interval in seconds for transmission of notifications.
The range is from 5 to 3600 secs. The default value is 5 seconds.
12. Click the APPLY button.
The settings are sent to the switch. Configuration changes take effect immediately. These
changes are not retained across a power cycle unless you save the configuration. See
Save Configuration

Configure an LLDP Interface


To configure an LLDP interface:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser.
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
M4100 Series Managed Switch
 
LLDP Global Configuration.
on page 405.
Configure System Information
91