Configure An Sflow Agent - NETGEAR M4100 Series User Manual

• Agent Version. Uniquely identifies the version and implementation of this MIB. The
version string must use the following structure: MIB Version;Organization;Software
Revision where:
- MIB Version: '1.3', the version of this MIB.
- Organization: NETGEAR Inc.
- Revision: 1.0
• Agent Address. The IP address associated with this agent.
8. In the Source Interface list, select the management interface to be used for sFlow Agent.
Possible values are as follows:
• None
• Routing interface
• Routing VLAN
• Routing loopback interface
• Tunnel interface
• Service port
By default, VLAN 1 is used as source interface.
9. Click the APPLY button.
The settings are sent to the switch. Configuration changes take effect immediately. These
changes are not retained across a power cycle unless you save the configuration. See
Save Configuration
To refresh the screen, click the REFRESH button to show the latest sFlow agent information.

Configure an sFlow Agent


To configure an sFlow agent:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser.
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
M4100 Series Managed Switch
on page 405.
Monitoring the System
399