Configure Acl Mac Binding - NETGEAR M4100 Series User Manual

The valid range of values is 0x0600 to 0xFFFF.
19. Use Source MAC to specify the wource MAC address to compare against an Ethernet
frame. The valid format is xx:xx:xx:xx:xx:xx.
20. Use Source MAC Mask to specify the wource MAC address mask specifying which bits in
the source MAC to compare against an Ethernet frame.
The valid format is xx:xx:xx:xx:xx:xx.
21. Use VLAN to specify the VLAN ID to compare against an Ethernet frame. The valid range of
values is 1 to 4095. Either VLAN Range or VLAN can be configured.
22. Logging. When set to 'Enable', logging is enabled for this ACL rule (subject to resource
availability in the device).
If the Access List Trap flag is also enabled, this causes periodic traps to be generated
indicating the number of times this rule was 'hit' during the current report interval. A fixed
5 minute report interval is used for the entire system. A trap is not issued if the ACL rule
hit count is zero for the current interval. This field is supported only for a Deny action.
23. Rate Limit Conform Data Rate. Value of Rate Limit Conform Data Rate specifies the
conforming data rate of MAC ACL rule.
The valid values are 1 to 4294967295 in Kbps.
24. Rate Limit Burst Size. Value of Rate Limit Burst Size specifies burst size of MAC ACL rule.
The valid values are 1 to 128 in Kbytes.
25. Time Range. Name of time range associated with the MAC ACL rule.
26. Use Rule Status. Displays if the ACL rule is active or inactive.
Blank means that no timer schedules are assigned to the rule.
27. To delete a rule, select the check box associated with the rule and click the DELETE button.
28. To change a rule, select the check box associated with the rule change the desired fields.
29. Click the APPLY button.
Configuration changes take effect immediately.

Configure ACL MAC Binding

When an ACL is bound to an interface, all the rules that were defined are applied to the
selected interface. You can assign MAC ACL lists to ACL priorities and interfaces.

To configure ACL MAC binding:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser.
4. Enter the IP address of the switch in the web browser address field.
M4100 Series Managed Switch
Manage Device Security
351