NETGEAR M4100 Series User Manual page 52
Managed switch
Hide thumbs
Also See for M4100 Series:
- Reference manual (578 pages) ,
- Hardware installation manual (34 pages) ,
- Software setup manual (27 pages)
Table of Contents
Advertisement
3.
Launch a web browser.
4.
Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5.
Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6.
Click the Login button.
The web management interface menu displays.
7.
Select System
Management
Configuration.
8.
Specify the Go To Interface by entering the Interface in unit/slot/port format and click the Go
button.
The entry corresponding to the specified Interface is selected.
9.
Select the Port.
10.
Use the Auto Power Down Mode selection to enable or disable this option.
The factory default is enable. When the port link is down the PHY automatically goes
down for short period of time, and then wakes up to check link pulses. This allows
performing autonegotiation and saving power consumption when no link partner is
present.
11.
Click the APPLY button.
The settings are sent to the switch. Configuration changes take effect immediately. These
changes are not retained across a power cycle unless you save the configuration. See
Save Configuration
M4100 Series Managed Switch
Green Ethernet
on page 405.
Configure System Information
52
Green Ethernet Interface
Hide quick links:
Advertisement
Table of Contents
