NETGEAR M4100 Series User Manual page 62

The following table describes the DHCP Pool Configuration fields.
Table 16. DHCP Pool configuration
Field
Pool Name*
Pool Name
Type of Binding
Network Address
Network Mask
Network Prefix Length
Client Name
Hardware Address
Hardware Address Type
Client ID
Host Number
Host Mask
Host Prefix Length
M4100 Series Managed Switch
Description
For a user with read/write permission, this field shows names of all the
existing pools along with an additional option Create. When you select
Create the Pool Name list displays. For a user with read-only
permission, this list shows only the names of the existing pools.
This field appears when the user with read-write permission selects
Create in the Pool Name list. Specifies the name of the pool to be
created. Pool Name can be up to 31 characters in length.
Specifies the type of binding for the pool:
• Unallocated
• Dynamic
• Manual
Specifies the subnet address for a DHCP address of a dynamic pool.
Specifies the subnet number for a DHCP address of a dynamic pool.
Either Network Mask or Prefix Length can be configured to specify the
subnet mask but not both.
Specifies the subnet number for a DHCP address of a dynamic pool.
Either Network Mask or Prefix Length can be configured to specify the
subnet mask but not both. The valid range is 0 to 32.
Specifies the client name for DHCP manual pool.
Specifies the MAC address of the hardware platform of the DHCP
client.
Specifies the protocol of the hardware platform of the DHCP client. The
valid types are Ethernet and ieee802. The default value is Ethernet.
Specifies the client Identifier for DHCP manual pool.
Specifies the IP address for a manual binding to a DHCP client. The
host can be set only if at least one client Identifier or hardware address
is specified. Deleting Host would delete Client Name, Client ID,
Hardware address for the manual pool and set the Pool Type to
Unallocated.
Specifies the subnet mask for a manual binding to a DHCP client.
Either Host Mask or Prefix Length can be configured to specify the
subnet mask but not both.
Specifies the subnet mask for a manual binding to a DHCP client.
Either Host Mask or Prefix Length can be configured to specify the
subnet mask but not both. The valid range is 0 to 32.
Configure System Information
62