NETGEAR M4100 Series User Manual page 421

• Tx = Count, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec
If a reply to the ping is received, the following messages display:
• Received response for Seq Num 0 Rtt xyz usec
• Received response for Seq Num 1 Rtt abc usec
• Received response for Seq Num 2 Rtt def usec
• Tx = Count, Rx = Count Min/Max/Avg RTT = xyz/abc/def msec.

To configure the settings and ping a host on the network:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser.
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select Maintenance
8. Use IP Address/Host Name to enter the IP address or host name of the station you want
the switch to ping.
The initial value is blank. The IP address or host name that you enter is not retained
across a power cycle.
9. Optionally, configure the following settings:
• Count. Enter the number of echo requests to send. The count you enter is not
retained across a power cycle.
M4100 Series Managed Switch
 
Troubleshooting Ping IPv4.
Maintenance
421