NETGEAR M4100 Series User Manual page 380

4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select Monitoring
8. Select the check box for the port to which the cable to be tested is connected.
9. Click the APPLY button.
A cable test is performed on the selected port. The cable test might take up to two seconds
to complete. If the port has an active link, the cable status is always Normal. The
command returns a cable length estimate if this feature is supported by the PHY for the
current link speed. If the link is down and a cable is attached to a 10/100 Ethernet
adapter, then the cable status can be Open or Short because some Ethernet adapters
leave unused wire pairs unterminated or grounded.
M4100 Series Managed Switch

Ports > Cable Test.
Monitoring the System
380