3. Type arp -d 192.11.13.6 and press Enter to clear the Address Resolution Protocol
(ARP) cache in the laptop. This command responds with one of the following:
The command line prompt when the cache has been cleared.
●
The phrase: The specified entry was not found.
●
This is returned when the specified IP address does not currently appear in the ARP
cache.
Logging into the IPSI
The following steps logs you into the IPSI.
1. Type telnet 192.11.13.6 and press Enter to open the Telnet window and connect to
the IPSI
Prompt = [IPSI]:
Note:
While connected to the IPSI, type help or ? to obtain online help. Most
Note:
commands have two or three letter abbreviations.
2. Type ipsilogin and press Enter (abbreviated command = il).
Note:
The craft login used on the IPSI has a different password than the craft login used
Note:
on the media servers.
3. Log in as craft.
Prompt = [IPADMIN]:
Setting the control interface
The following steps set the control interface.
1. Type show control interface and press Enter.
2. Type show port 1 and press Enter to see the current settings.
Programming the IPSI circuit packs
Issue 3.1 June 2005
71