Samp Connections; Samp Software - Avaya S8500 Installing And Configuring

Hide thumbs Also See for S8500:
Table of Contents

Advertisement

Introduction

SAMP connections

The SAMP card is installed in PCI-X slot 1 (full-height, 3/4 length slot) of the Avaya S8500
Media Server.
The SAMP comes in a half-card PCI form factor and is powered externally. It supports one USB
interface and two 10/100 Ethernet ports that are located on the rear of the media server.
SAMP Ethernet 1 is not used.
SAMP Ethernet 2 is for local Services laptop access. This is for on-site services personnel
to access the SAMP using the craft login.
The USB interface is used to connect a USB modem that is used for remote dial-in and
dial-out access. This modem connection is shared between the media server and the
SAMP for remote maintenance, administration, and alarming purposes. For dial-in
purposes, the user first establishes a ppp session that terminates at the SAMP. The user
then can establish an SSH (Secure Shell) or HTTPS (Secure Web) session to the SAMP
or the host using the craft login.
The SAMP also communicates with the host in-band via an on-board industry standard Ethernet
controller on the host's PCI bus with an internal link to the SAMP.
See
Figure 1: SAMP rear connections
Figure 1: SAMP rear connections
Figure notes:
1. SAMP Eth2—to services laptop
(cross-connect CAT5 cable)
2. SAMP Eth1 (not used)

SAMP software

The SAMP is shipped from the factory with software installed and with some default settings.
However, you may need to install an updated version of the software and you must configure
the SAMP before it can be used.
If a SAMP software update file is available on the Avaya Support website, you should have
downloaded it to your laptop. See The Avaya Server Availability Management Processor User
Guide, 03-300322, for details on installing software on the SAMP and changing default settings.
24 Installing and Configuring the Avaya S8500 Media Server
for locations of the connections on the SAMP.
1
2
3. USB connection for the modem
4. External power to the SAMP
1
2
3
4
h2ms85b2 KLC 093004

Advertisement

Table of Contents
loading

Table of Contents