Conventions; General - Avaya S8500 Installing And Configuring

About this Documentation
For the physical installation and cabling of the hardware, see the Quick Start for Hardware
Installation: Avaya S8500 Media Server (555-245-701). Use the remaining sections of the
document in the sequence they are presented. If certain components are not to be installed,
skip the procedures for those components. You install and configure the media server
components using information in the following sections:
Configuring the SNMP modules in the UPS
●
Configuring the SNMP subagent in the Avaya Ethernet switch (if used)
●
Configuring the media server
●
Configuring the dual network interface card
●
Translating the IPSIs
●
You next install the media gateways, using sections in Installing the Avaya G650 Media
Gateway (03-300144).
Connect the system to the customer's network using information in
page 65.
Complete the installation using information in the following sections:
Completing the installation administration
●
Testing the media server installation
●
Accessing the media server
●
If problems occur during the installation, use
to resolve them.

Conventions

This section describes the conventions that we use in this book.

General

We show commands and screens from the newest system and refer to the most current books.
You must substitute the appropriate commands for your system and refer to the books that you
have available.
10 Installing and Configuring the Avaya S8500 Media Server
on page 44
on page 59
on page 79
on page 89
on page 101
Troubleshooting an installation
on page 32
on page 55
Connecting to the IPSIs
on page 35
on
on page 111 to try