Avaya S8500 Installing And Configuring page 37

Hide thumbs Also See for S8500:

Table of Contents

8. Set spanning tree version to rapid-spanning-tree (not the default). This command is

available on Avaya P363 Ethernet switches having firmware version 4.0 or later. You must

update the firmware to this version to use the command.

Use the command set spantree version rapid-spanning-tree.

Note:

For more information on the Spanning Tree CLI commands, see Installation and

Note:

Configuration Guide, Avaya C360 and Reference Guide, Avaya C360, available

at the Avaya Support Web site (http://www.avaya.com/support).

9. If IP Connect, make sure all appropriate ports on the Ethernet switch are locked to 100

speed using full duplex.

10. When completed, disconnect the services laptop computer from the Ethernet switch.

11. If two Ethernet switches are present for CNA, repeat steps 1 through 7 for the second

switch.

Configuring the SNMP subagent in the Avaya Ethernet switch (if used)

Issue 3.1 June 2005

Table of Contents