Chapter 3: Installing Communication Manager Software - Avaya S8500 Installing And Configuring

Chapter 3: Installing Communication Manager
A new media server comes with a blank hard drive. The Linux operating system and Release
3.0 of Avaya Communication Manager must be installed on the media server from the bootable
software distribution CD-ROM.
Use the instructions in Quick Start for Hardware Installation: Avaya S8500 Media Server
(555-245-701) to install the media server in the data rack. After installing the media server, you
must install the software from the CD onto the hard drive.
Note:
If you are installing an S8500B Media Server to run the Expanded Meet-me
Note:
Conferencing (EMMC) application, the software will be on two CDs labeled
EMMC Software Disk 1 and EMMC Software Disk 2.
This section covers the following tasks:
Clearing the ARP cache on the laptop
●
Powering up the media server
●
Powering up the media server
●
Accessing the media server
●
Configuring Telnet for Windows 2000/XP
●
Installing Avaya Communication Manager
●
!
Important:
If you are installing an S8500B Media Server to run the Expanded Meet-me
Important:
Conferencing (EMMC) application, follow the instructions in this section up to and
including
Expanded Meet-me Conferencing (EMMC) version 1.0 Installation and
Troubleshooting Guide, 04-300527 to complete the installation of the EMMC.
software
on page 40
on page 40
on page 40
Installing Avaya Communication Manager
on page 40
on page 41
on page 42
on page 42. Then, go to
Issue 3.1 June 2005 39